EPS 3000   Potentiometer generator Response time < 2 ms Flexibility Fast installation   ELECTRONIC THROTTLE CONTROL FOR ENGINE TEST BEDS EPS 3000 can simulate an accelerator pedal sensor in order to drive the engine computer set point. It can control also a mechanical actuator (type AT-LIN). One series of 8 LEDs displays the load level while another shows the operating modes and alarms. Concerning the engine computer, the EPS 3000 copies the electrical pedal behaviour from a set point, either in analogue mode (0-10 V), or in digital mode (16 bits). Moreover, the electrical behaviour is modelled by a voltage curve. The configuration software makes it possible to program this voltage curve (between 0 and 10 V) according to the set point (0 to 100 %).